Technical Data Sheet
| physical property | Test Condition | Test Method | Test Result | Unit |
|---|
| Melt mass flow rate | 343°C/2.16kg | ASTMD1238 | 6.5 | g/10min |
| Shrinkage rate | MD | ASTMD955 | 0.70 | % |
| Water absorption rate | 24hr | ASTMD570 | 0.30 | % |
| Density/specific gravity | | ASTMD792 | 1.24 | g/cm³ |
| Mechanical performance | Test Condition | Test Method | Test Result | Unit |
|---|
| Tensile strength | | ASTMD638 | 70.3 | Mpa |
| Tensile modulus | | ASTMD638 | 2480 | Mpa |
| elongation | 断裂 | ASTMD638 | 50to100 | % |
| Bending modulus | | ASTMD790 | 2690 | Mpa |
| bending strength | | ASTMD790 | 106 | Mpa |
| Thermal performance | Test Condition | Test Method | Test Result | Unit |
|---|
| Hot deformation temperature | 1.8MPa,未退火 | ASTMD648 | 174 | °C |
| Linear coefficient of thermal expansion | MD | ASTMD696 | 5.6E-05 | cm/cm/°C |
| Electrical performance | Test Condition | Test Method | Test Result | Unit |
|---|
| Dielectric strength | | ASTMD149 | 17 | KV/mm |
| Dissipation factor | 1MHz | ASTMD150 | 6E-03 | |
| Dissipation factor | 60Hz | ASTMD150 | 7E-04 | |
| Dissipation factor | 1kHz | ASTMD150 | 1E-03 | |
| Dielectric constant | 60Hz | ASTMD150 | 3.03 | |
| Dielectric constant | 1kHz | ASTMD150 | 3.04 | |
| Dielectric constant | 1MHz | ASTMD150 | 3.02 | |
| Volume resistivity | | ASTMD257 | 3E+16 | ohms·cm |
| Impact performance | Test Condition | Test Method | Test Result | Unit |
|---|
| Tensile impact strength | | ASTMD1822 | 420 | kJ/m² |
| Impact strength of cantilever beam gap | | ASTMD256 | 69 | J/m |
| flammability | Test Condition | Test Method | Test Result | Unit |
|---|
| UL flame retardant rating | 1.5mm,ALL | UL94 | HB | |
| UL flame retardant rating | 4.5mm,NC | UL94 | V-0 | |
| Burning wire flammability index | 0.8mm | IEC60695-2-12 | 850 | °C |
| Burning wire flammability index | 1.6to6.0mm | IEC60695-2-12 | 960 | °C |
| Hot filament ignition temperature | 0.8mm | IEC60695-2-13 | 875 | °C |
| Hot filament ignition temperature | 1.6to6.0mm | IEC60695-2-13 | 850 | °C |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.
Compare
View Prices