Technical Data Sheet
| physical property | Test Condition | Test Method | Test Result | Unit |
|---|
| Shrinkage rate | 2.00mm | 内部方法 | 0.20to0.45 | % |
| Water absorption rate | 23°C,24hr | ISO62 | 0.060 | % |
| Mechanical performance | Test Condition | Test Method | Test Result | Unit |
|---|
| Tensile stress | 屈服,23°C | ISO527-2 | 80.0 | Mpa |
| Tensile strain | 断裂,23°C | ISO527-2 | 2.0 | % |
| Bending modulus | 23°C | ISO178 | 7060 | Mpa |
| Bending stress | 23°C | ISO178 | 138 | Mpa |
| Thermal performance | Test Condition | Test Method | Test Result | Unit |
|---|
| Linear coefficient of thermal expansion | MD：-30到65°C | ISO11359-2 | 4E-05 | cm/cm/°C |
| Hot deformation temperature | 1.8MPa,未退火 | ASTMD648 | 120 | °C |
| Hot deformation temperature | 1.8MPa,未退火 | ISO75-2/A | 118 | °C |
| Electrical performance | Test Condition | Test Method | Test Result | Unit |
|---|
| Surface resistivity | | IEC60093 | 1E+16 | ohms |
| Dielectric constant | 100Hz | IEC60250 | 3.30 | |
| Dielectric constant | 1MHz | IEC60250 | 3.20 | |
| Volume resistivity | 23°C | IEC60093 | 1E+16 | ohms·cm |
| Dissipation factor | 100Hz | IEC60250 | 6E-03 | |
| Dissipation factor | 1MHz | IEC60250 | 8E-03 | |
| Impact performance | Test Condition | Test Method | Test Result | Unit |
|---|
| Impact strength of simply supported beam gap 3 | 23°C | ISO179 | 5.0 | kJ/m² |
| flammability | Test Condition | Test Method | Test Result | Unit |
|---|
| UL flame retardant rating | 0.40mm | UL94 | HB | |
| UL flame retardant rating | 0.75mm | UL94 | V-1 | |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.
Compare
View Prices