Technical Data Sheet
Physical Properties | Test Condition | Test Method | Test Result | Unit |
---|
Moisture Absorption | 24 hr | ASTM D570 | 0.15 | % |
Modeling Shrinkage - Flow | 3.18 mm | ASTM D955 | 0.15 | % |
Mechanical Properties | Test Condition | Test Method | Test Result | Unit |
---|
Tensile Strength | 23°C | ASTM D638 | 121 | Mpa |
Tensile Modulus | 23°C | ASTM D638 | 9720 | Mpa |
Tensile Elongation | Break, 23°C | ASTM D638 | 2.0 | % |
Flexural Modulus | 23°C | ASTM D790 | 11000 | Mpa |
Flexural Strength | 23°C | ASTM D790 | 172 | Mpa |
Thermal Properties | Test Condition | Test Method | Test Result | Unit |
---|
Deflection Temperature Under Load? | 0.45 MPa, Unannealed | ASTM D648 | 146 | °C |
Deflection Temperature Under Load? | 1.8 MPa, Unannealed | ASTM D648 | 142 | °C |
Coefficient of Linear Thermal Expansion (Flow) | | ASTM D696 | 3.2E-5 | cm/cm/°C |
Electrical performance | Test Condition | Test Method | Test Result | Unit |
---|
Surface Resistivity | | ASTM D257 | 1.0E+2 到 5.5E+5 | ohms |
Volume Resistivity | | ASTM D257 | 1.0E+2 到 1.0E+5 | ohms·cm |
Injection | Test Condition | Test Method | Test Result | Unit |
---|
Drying Temperature | | | 121 | °C |
Suggested Max Moisture | | | 0.10 | % |
Processing (Melt) Temp | | | 304 到 327 | °C |
Mold Temperature | | | 71 到 88 | °C |
Drying Time | | | 2.0 到 4.0 | hr |
Rear Temperature | | | 302 到 316 | °C |
Middle Temperature | | | 316 到 332 | °C |
Front Temperature | | | 310 到 327 | °C |
Nozzle Temperature | | | 310 到 327 | °C |
Back Pressure | | | 0.00 到 0.689 | Mpa |
Injection Rate | | | 中等 | |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.