Technical Data Sheet
Physical Properties | Test Condition | Test Method | Test Result | Unit |
---|
Melt Mass-Flow Rate | 337°C/6.6 kg | ASTM D1238 | 4.6 | g/10 min |
Modeling Shrinkage | Flow : 3.20 mm | 内部方法 | 0.15 到 0.25 | % |
Modeling Shrinkage | Across Flow : 3.20 mm | 内部方法 | 0.30 到 0.50 | % |
Mechanical Properties | Test Condition | Test Method | Test Result | Unit |
---|
Tensile Strength | Break | ASTM D638 | 131 | Mpa |
Tensile Elongation | Break | ASTM D638 | 1.4 | % |
Flexural Modulus | 100 mm Span | ASTM D790 | 12400 | Mpa |
Flexural Strength | Break, 100 mm Span | ASTM D790 | 179 | Mpa |
Thermal Properties | Test Condition | Test Method | Test Result | Unit |
---|
Deflection Temperature Under Load? | 1.8 MPa, Unannealed, 6.40 mm | ASTM D648 | 212 | °C |
RTI Elec | | UL 746 | 180 | °C |
RTI Imp | | UL 746 | 180 | °C |
RTI | | UL 746 | 180 | °C |
Electrical performance | Test Condition | Test Method | Test Result | Unit |
---|
Arc Resistance | | ASTM D495 | PLC 5 | |
Comparative Tracking Index | | UL 746 | PLC 4 | |
High Amp Arc Ignition | | UL 746 | PLC 4 | |
High Voltage Arc Tracking Rate | | UL 746 | PLC 4 | |
Hot-wire Ignition | | UL 746 | PLC 1 | |
Injection | Test Condition | Test Method | Test Result | Unit |
---|
Drying Temperature | | | 150 | °C |
Drying Time | | | 4.0 到 6.0 | hr |
Suggested Max Moisture | | | 0.020 | % |
Suggested Shot Size | | | 40 到 60 | % |
Rear Temperature | | | 330 到 400 | °C |
Middle Temperature | | | 340 到 400 | °C |
Front Temperature | | | 345 到 400 | °C |
Nozzle Temperature | | | 345 到 400 | °C |
Processing (Melt) Temp | | | 350 到 400 | °C |
Mold Temperature | | | 135 到 165 | °C |
Back Pressure | | | 0.300 到 0.700 | Mpa |
Screw Speed | | | 40 到 70 | rpm |
Vent Depth | | | 0.025 到 0.076 | mm |
Impact Properties | Test Condition | Test Method | Test Result | Unit |
---|
Reverse Notch Izod Impact | 3.20 mm | ASTM D256 | 220 | J/m |
Flammability | Test Condition | Test Method | Test Result | Unit |
---|
Flame Rating | 0.77 mm | UL 94 | V-0 | |
Flame Rating | 3.0 mm | UL 94 | 5VA | |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.