Technical Data Sheet
Physical Properties | Test Condition | Test Method | Test Result | Unit |
---|
Modeling Shrinkage | MD:193°C | ASTMD955 | 0.90到1.5 | % |
Melt Mass-Flow Rate | 190°C/2.16kg | ASTMD1238 | 1.0到12 | g/10min |
Melt Mass-Flow Rate | 200°C/5.0kg | ASTMD1238 | 15到25 | g/10min |
Elastomers Properties | Test Condition | Test Method | Test Result | Unit |
---|
Compression Set | 23°C,22hr | ASTMD395 | 24 | % |
Tensile Stress | 100%Strain,23°C | ASTMD412 | 3.07 | Mpa |
Tensile Stress | 300%Strain,23°C | ASTMD412 | 5.10 | Mpa |
Tensile Strength | Break,23°C | ASTMD412 | 15.2 | Mpa |
Tensile Elongation | Break,23°C | ASTMD412 | 640 | % |
Tearing Strength | 23°C | ASTMD624 | 52.5 | kN/m |
Fill Analysis | Test Condition | Test Method | Test Result | Unit |
---|
pparent Viscosity | 200°C,11200sec^-1 | ASTMD3835 | 16.0 | Pa·s |
hardness | Test Condition | Test Method | Test Result | Unit |
---|
Shore Hardness | Shore A,10sec | ASTMD2240 | 65 | |
Flammability | Test Condition | Test Method | Test Result | Unit |
---|
UL flame retardant rating | 1.5to13.0mm,全部 | UL94 | HB | |
Supplementary information | Test Condition | Test Method | Test Result | Unit |
---|
MassLoss-500CycleAbrasionResistance6 | 23°C | ASTMD3389 | 2.0 | mg |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.