Technical Data Sheet
Physical Properties | Test Condition | Test Method | Test Result | Unit |
---|
Modeling Shrinkage | Flow | ISO 2577 | 0.85 | % |
Modeling Shrinkage | 垂直Flow | ISO 2577 | 0.85 | % |
Moisture Absorption | 23℃Saturation值 | ISO 62 | 0.4 | % |
Hygroscopicity | 23℃/50%相对湿度,Saturation值 | ISO 62 | 0.2 | % |
Melt Volume flow Rate | 330℃/2.16kg | ISO 1133 | 10/10 | CM |
Melt Mass-Flow Rate | 330℃/2.16kg | ISO 1133 | 10/10 | g/(10min) |
Mechanical Properties | Test Condition | Test Method | Test Result | Unit |
---|
Flexural Strength | 5mm/mim | ISO 178 | 95 | Mpa |
Flexural Modulus | 2mm/mim | ISO 178 | 2200 | Mpa |
Tensile Stress (Yield) | 50mm/mim | ISO 527-1-2 | 7 | % |
Ball Indentation Hardness | | ISO 2309-1 | 115 | N/mm |
Tensile Modulus | 1mm/mim | ISO 527-1-2 | 2300 | Mpa |
Tensile Stress (Yield) | 50mm/mim | ISO 527-1-2 | 65 | Mpa |
Elongation at break | 50mm/mim | ISO 527-1-2 | >50 | % |
Thermal Properties | Test Condition | Test Method | Test Result | Unit |
---|
Deflection Temperature Under Load? | 1.80Mpa | ISO 75-1,-2 | 162/151/160 | °C |
Coefficient of Linear Thermal Expansion (Flow) | 23~55℃ | ASTME811 | 0.7 | |
Coefficient of Linear Thermal Expansion (Across Flow) | 23~55℃ | ASTME811 | 0.7 | |
Electrical performance | Test Condition | Test Method | Test Result | Unit |
---|
Dissipation Factor? | 100Hz/1MHz | 1EC250 | 13/100 | |
Processing | Test Condition | Test Method | Test Result | Unit |
---|
Mold Temperature | | ISO 294 | 200 | mm/g |
Melt Temperature | | ISO 294 | 330 | °C |
Mold Temperature | | ISO 294 | 100 | °C |
Other | Test Condition | Test Method | Test Result | Unit |
---|
Oxygen Index | | ISO 4589 | 24 | % |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.