Technical Data Sheet
Physical Properties | Test Condition | Test Method | Test Result | Unit |
---|
Moisture Absorption | 24 hr, 23°C | ASTM D570 | 0.70 | % |
Modeling Shrinkage - Flow | 23°C, 3.20 mm, Injection | ASTM D955 | 0.70 到 1.2 | % |
Mechanical Properties | Test Condition | Test Method | Test Result | Unit |
---|
Tensile Elongation | Break, 23°C, 3.20 mm, Injection | ASTM D638 | 3.0 | % |
Flexural Modulus | 23°C, 3.20 mm, Injection | ASTM D790 | 4900 | Mpa |
Flexural Strength | 23°C, 3.20 mm, Injection | ASTM D790 | 142 | Mpa |
Tensile Strength | Yield, 23°C, 3.20 mm, Injection | ASTM D638 | 98.1 | Mpa |
Thermal Properties | Test Condition | Test Method | Test Result | Unit |
---|
Coefficient of Linear Thermal Expansion (Flow) | | ASTM D696 | 3.0E-5 | cm/cm/°C |
Peak Melting Temperature | | ASTM D3418 | 260 | °C |
Deflection Temperature Under Load? | 1.8 MPa, Unannealed, 6.40 mm, Injection | ASTM D648 | 230 | °C |
Electrical performance | Test Condition | Test Method | Test Result | Unit |
---|
Comparative Tracking Index | Solution A | IEC 60112 | 250 | V |
Dielectric Strength | 23°C, 1.00 mm | ASTM D149 | 22 | KV/mm |
Dielectric Constant | 23°C, 1 MHz | ASTM D150 | 3.00 | |
Volume Resistivity | 23°C | ASTM D257 | 1.0E+14 | ohms·cm |
Injection | Test Condition | Test Method | Test Result | Unit |
---|
Drying Temperature | | | 80 到 100 | °C |
Suggested Max Moisture | | | 0.10 | % |
Processing (Melt) Temp | | | 270 到 290 | °C |
Mold Temperature | | | 80 到 110 | °C |
Drying Time | | | 4.0 到 5.0 | hr |
Rear Temperature | | | 265 到 275 | °C |
Middle Temperature | | | 270 到 280 | °C |
Front Temperature | | | 270 到 285 | °C |
Nozzle Temperature | | | 270 到 280 | °C |
Back Pressure | | | 0.981 到 2.94 | Mpa |
Screw Speed | | | 60 到 150 | rpm |
hardness | Test Condition | Test Method | Test Result | Unit |
---|
Rockwell Hardness | R-Scale, 23°C, Injection | ASTM D785 | 120 | |
Flammability | Test Condition | Test Method | Test Result | Unit |
---|
Flame Rating | 0.8 mm | UL 94 | V-0 | |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.