Technical Data Sheet
Physical Properties | Test Condition | Test Method | Test Result | Unit |
---|
Moisture Absorption | 24 hr, 23°C | ASTM D570 | 0.60 | % |
Modeling Shrinkage - Flow | 23°C, 3.20 mm, Injection | ASTM D955 | 0.30 到 0.70 | % |
Mechanical Properties | Test Condition | Test Method | Test Result | Unit |
---|
Tensile Strength | Break, 23°C, 3.20 mm, Injection | ASTM D638 | 196 | Mpa |
Tensile Elongation | Break, 23°C, 3.20 mm, Injection | ASTM D638 | 3.0 | % |
Flexural Modulus | 23°C, 3.20 mm, Injection | ASTM D790 | 11800 | Mpa |
Flexural Strength | 23°C, 3.20 mm, Injection | ASTM D790 | 275 | Mpa |
Thermal Properties | Test Condition | Test Method | Test Result | Unit |
---|
Peak Melting Temperature | | ASTM D3418 | 220 | °C |
Deflection Temperature Under Load? | 1.8 MPa, Unannealed, 6.40 mm, Injection | ASTM D648 | 210 | °C |
Coefficient of Linear Thermal Expansion (Flow) | | ASTM D696 | 3.0E-5 | cm/cm/°C |
Electrical performance | Test Condition | Test Method | Test Result | Unit |
---|
Dielectric Strength | 23°C, 1.00 mm | ASTM D149 | 25 | KV/mm |
Dielectric Constant | 23°C, 1 MHz | ASTM D150 | 4.00 | |
Volume Resistivity | 23°C | ASTM D257 | 1.0E+16 | ohms·cm |
Injection | Test Condition | Test Method | Test Result | Unit |
---|
Drying Temperature | | | 80 到 100 | °C |
Processing (Melt) Temp | | | 270 到 295 | °C |
Mold Temperature | | | 80 到 110 | °C |
Drying Time | | | 4.0 到 5.0 | hr |
Rear Temperature | | | 260 到 270 | °C |
Middle Temperature | | | 270 到 285 | °C |
Front Temperature | | | 270 到 290 | °C |
Nozzle Temperature | | | 270 到 295 | °C |
Back Pressure | | | 29.4 到 58.8 | Mpa |
Screw Speed | | | 30 到 60 | rpm |
hardness | Test Condition | Test Method | Test Result | Unit |
---|
Rockwell Hardness | R-Scale, 23°C, Injection | ASTM D785 | 120 | |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.