Technical Data Sheet
Physical Properties | Test Condition | Test Method | Test Result | Unit |
---|
Melt index | 260℃,5kg | ASTM D-1238 | 26 | g/10min |
Melting Temperature | | MCI方法 | 240 | °C |
Mechanical Properties | Test Condition | Test Method | Test Result | Unit |
---|
Rockwell Hardness | | ASTM D-785 | R85 | |
Tensile Elongation | Break | ASTM D-638 | 25 | % |
Tensile Strength (Yield) | | ASTM D-638 | 235 | kg/cm |
Tensile Strength | | ASTM D-638 | 175 | kg/cm |
Charpy Notched Impact Strength | | ASTM D-256 | 5 | kgcm/cm |
Notched Izod Impact Strength | | ASTM D-256 | 15 | kgcm/cm |
Flexural Modulus | | ASTM D-790 | 13,000 | kg/cm |
Olsen rigidity | | ASTM D-747 | 10,000 | kg/cm |
Flexural Strength | | ASTM D-790 | 360 | kg/cm |
Thermal Properties | Test Condition | Test Method | Test Result | Unit |
---|
Coefficient of Linear Thermal Expansion | | ASTM D-696 | 1.17*10 | 1/℃ |
Modeling Shrinkage | 机械/Across Flow | MCI方法 | 2.1/1.7 | % |
Specific Heat | | ASTM C-351 | 0.47 | cal/g℃ |
Burning Rate | | ASTM D-635 | 2.54 | cm/min |
Thermal Conductivity | | ASTM BS-847A | 4*10 | calcm/seccm |
Deflection Temperature Under Load? | 4.6kg/cm | ASTM D-648 | 90 | °C |
Vicat Softening Temperature | | ASTM D-1525 | 173 | °C |
Electrical performance | Test Condition | Test Method | Test Result | Unit |
---|
Volume Resistivity | | ASTM D-257 | >10 | Ωcm |
Dissipation Factor? | 23℃,1MHz | ASTM D-150 | 0.0007 | |
Moisture Absorption | 24hr | ASTM D-570 | 0.01 | % |
Dielectric Constant | 100~1MHz | ASTM D-150 | 2.12 | |
Dielectric Strength | | ASTM D-149 | 65 | KV/mm |
Other | Test Condition | Test Method | Test Result | Unit |
---|
Transmittance | | ASTM D-1746 | 92 | % |
Haze | | ASTM D-1746 | 1.5 | % |
Refractive index of light | | ASTM D-542 | 1.463 | ND |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.