Technical Data Sheet
Physical Properties | Test Condition | Test Method | Test Result | Unit |
---|
Modeling Shrinkage | TD | 内部方法 | 0.50to0.80 | % |
Modeling Shrinkage | MD | 内部方法 | 0.10to0.40 | % |
Moisture Absorption | Equilibrium,23°C,50%RH | ISO62 | 0.010 | % |
Mechanical Properties | Test Condition | Test Method | Test Result | Unit |
---|
Tensile Stress | Break | ISO527-2 | 125 | Mpa |
Tensile Strain | Break | ISO527-2 | 2.0 | % |
Tensile Modulus | | ISO527-2 | 9700 | Mpa |
Flexural Modulus | | ISO178 | 9800 | Mpa |
Flexural Stress | | ISO178 | 200 | Mpa |
Thermal Properties | Test Condition | Test Method | Test Result | Unit |
---|
Linear thermal expansion coefficient | MD:-30to30°C | TMA | 1.8E-05 | cm/cm/°C |
Linear thermal expansion coefficient | TD:-30to30°C | TMA | 4.3E-05 | cm/cm/°C |
RTIElec | | UL746 | 50.0 | °C |
Evolution Calendar intelligent importer | | UL746 | 50.0 | °C |
RTIStr | | UL746 | 50.0 | °C |
Deflection Temperature Under Load? | 0.45MPa,Unannealed | ISO75-2/B | 270 | °C |
Deflection Temperature Under Load? | 1.8MPa,Unannealed | ISO75-2/A | 250 | °C |
Electrical performance | Test Condition | Test Method | Test Result | Unit |
---|
Dielectric Constant | 1MHz | IEC60250 | 2.90 | |
Volume Resistivity | | IEC60093 | >1.0E+16 | ohms·cm |
Dissipation Factor? | 1MHz | IEC60250 | <1.0E-3 | |
Dielectric Strength | | ASTMD149 | 45 | KV/mm |
Comparative Tracking Index | CTI)3 | IEC60112 | PLC1 | |
Impact Properties | Test Condition | Test Method | Test Result | Unit |
---|
Notched Izod impact strength | 23°C | ISO180 | 32 | kJ/m² |
Charpy Unnotched Impact Strength | 23°C | ISO179 | 40 | kJ/m² |
Flammability | Test Condition | Test Method | Test Result | Unit |
---|
UL flame retardant rating | 0.8to3.0mm,全部 | UL94 | HB | |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.