Technical Data Sheet
Compare
| physical property | Test Condition | Test Method | Test Result | Unit |
|---|
| Shrinkage rate - flow | 3.20 mm | ASTM D955 | 0.60 到 0.80 | % |
| water content | | | < 0.020 | % |
| Mechanical performance | Test Condition | Test Method | Test Result | Unit |
|---|
| Tensile modulus | | ASTM D638 | 2140 | Mpa |
| Tensile strength | | ASTM D638 | 58.6 | Mpa |
| elongation | Yield | ASTM D638 | 8.0 | % |
| Bending modulus | | ASTM D790 | 2280 | Mpa |
| bending strength | | ASTM D790 | 82.0 | Mpa |
| Thermal performance | Test Condition | Test Method | Test Result | Unit |
|---|
| Thermal deformation temperature under load | 1.8 MPa, Unannealed | ASTM D648 | 64.4 | °C |
| Electrical performance | Test Condition | Test Method | Test Result | Unit |
|---|
| Surface resistivity | -- | ESD STM11.11 | 1.0E+5 到 1.0E+9 | ohms |
| Surface resistivity | -- | ASTM D257 | 1.0E+6 到 1.0E+10 | ohms |
| Volume resistivity | | ASTM D257 | 1.0E+2 到 1.0E+5 | ohms·cm |
| Static Decay | | FTMS 101C 4046.1 | < 2.0 | sec |
| injection | Test Condition | Test Method | Test Result | Unit |
|---|
| drying temperature | | | 79 | °C |
| drying time | | | 4.0 | hr |
| Dew Point | | | -40 | °C |
| Processing (melt) temperature | | | 232 到 282 | °C |
| Mold temperature | | | 49 到 93 | °C |
| Injection pressure | | | 68.9 到 103 | Mpa |
| Impact performance | Test Condition | Test Method | Test Result | Unit |
|---|
| Non notched cantilever beam impact | 3.20 mm | ASTM D4812 | 无断裂 | |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.
